| |
|
|
|
|
|
Category
Laparoscopic Reusable Electrodes Working Length 32cm Outside Diameter 4.8mm
Description
L-Hook Lap Electrode Pen Connector
Case Qty
1
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|
|
|
|
|
Category
Laparoscopic Reusable Electrodes Working Length 32cm Outside Diameter 4.8mm
Description
L-Hook Lap Electrode Cable Connector
Case Qty
1
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|
|
|
|
|
Category
Laparoscopic Reusable Electrodes Working Length 32cm Outside Diameter 4.8mm
Description
Spatula Lap Electrode Cable Connector
Case Qty
1
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|
|
|
|
|
A Set of 5 color-coded ECG Limb Cables, labelled RA, LA, RL, LL and C, are offered.
Each cable is 1 m (3.3 ft) long. One end has a 2 mm plug for connecting to the
BS4 50-9513 Isolated Preamplifier, see page I62. The other end has a 4 mm plug
that connects directly to Plate and Suction Electrodes or to a Snap Fastener
Connector for use with Disposable Electrodes. These Electrodes, Cables and
accessories are available individually or as a complete set BS4 50-9844.
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|
|
|
|
|
The AIM-8-V3 uses a shielded five-wire impedance electrode cable assembly for sensing the subject’s bioelectric-impedance and ECG signals. Each of the five wires is a shielded coaxial cable, which prevents the two mA current electrodes from having high frequency cross talk with the impedance detection ECG electrodes. The subject electrode cable assembly is typically 34" long and is terminated with a DB-9 male plug which mates with the corresponding receptacle on the AIM-8-V3 monitor.
The electrode lead-wires are numbered 1 through 5 for easy identification. Leads 1 and 4 are the current excit
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|
|
|
|
|
Manufactured using advanced robotic production
techniques, these needles are some of the most
consistent and accurate available. Each needle is
microscopically checked by sophisticated visual
inspection systems at all vital stages during production.
An ergonomic hub design with an index
mark provides improved control. Color-coded hub
for easy identification. The shielded, 40” (100 cm)
long reusable cable has a 5-pin DIN connector. Sold
Separately.
Single patient use only. Cable is reusable.
|
Company:
Date:
October 27, 2008
|
|
|
|
|
|
|
|
|
|
Ground electrode with attached lead wire is easily repositioned
and conforms to the curves of the body. Utilizes a special green
tab which makes it easy to grasp. Lead wire is 100cm (40”) long.
Each individual electrode is packaged in a foil pouch for longer
shelf life. Sold in packs of 10 electrodes.
|
Company:
Date:
October 29, 2008
|
|
|
|
|
|
|
|
|
|
Self adhesive electrodes are easy to reposition and feature high
quality silver/silver chloride sensor for optimum signal quality.
Color coded lead wires come in either 50cm or 80cm (20”, 32”).
Package contains 4 sets with 3 electrodes each
|
Company:
Date:
October 29, 2008
|
|
|
|
|
|
|
|
|
|
Neurometer® CPT Coiled Electrode Base Cables provies a flexible, distortion free interface between the CPT system and the CBEX-4 electrode cable. The tangle-free coiled design allows distal sites to be tested without moving the patient or the equipment.
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|
|
|
|
|
Neurometer® CPT Electrode Extension Cables feature ultra-flexible, lightweight lead wires terminated with spring loaded molded electrode holders. High quality construction and materials assure the undistorted transmission of the stimulus and minimize the introduction of sensory artifacts that can unnecessarily complicate and lengthen the examination procedure.
|
Company:
Date:
October 31, 2008
|
|
|
|
|
|